Average Reviews:
(More customer reviews)It took a little longer to get than expected, but after using it the wait was worth it. I have done several test on the controller at room temp. 72'F Yellow charging light is on until battery voltage hits 14.35 volts, then the green fully charged light comes on and the battery stops charging until the battery reaches 13.25 volts then it starts charging again. AMP loss going through controller is only .02 amp's and that makes this a great controller. It has a connector for 12 volt load that shuts off at 11 volts and turns back on at 12 volts, I don't use the load connector, I have a power invertor hooked directly to the battery that shuts off at 11 volts although I never let the battery get that low because it's hard on the battery when you have 4-5 cloudy days in a row. Even deep cycle batteries will go bad if they sit around discharged. I bought the Allstar ALL76232 universal 2 wire connector to hook up the controller too the battery and a 50 watt solar panel.
Click Here to see more reviews about: KINTREX SPC0601 Solar Charge Controller - 7Amp, 100 Watt, Digital LED Display
The SPC0601 Solar Charge Controller is designed to protect batteries from overcharge and excessive discharge when being charged by a solar panel device. The controller functions to automatically assure the battery is fully charged and keep the battery fully charged without damage to the battery. The SPC0601 Charge Controller also functions to limit the load placed upon the battery to ensure the battery is not discharged to the point where there is permanent damage to the battery. The SPC0601 is a completely solid state electronic device needing no maintenance. It utilizes the latest in solid state MOSFET switching for efficient and reliable operation. The controller provides three colored LEDs to indicate the status of the solar panel and battery:
Green LED: On indicates the battery is fully charged.Yellow LED: On indicates the battery is charging.Note: It is normal for the Green and Yellow LEDs to flicker back and forth during normal operation.Red LED: On indicates the battery level is low. Output load is disabled.Advantages of Using KINTREX Solar Charge Controllers- Maintenance free. Solid state electronics.- Easy to use. Quick connect SAE 2-Pin connectors.- High efficiency, low self-consumption. Efficient MOSFET switching.- High input power - 100 Watt.- Compatible with KINTREX solar panels and many other manufacturers such as Sunforce(TM).
Buy cheap KINTREX SPC0601 Solar Charge Controller - 7Amp, 100 Watt, Digital LED Display now.
No comments:
Post a Comment